Inventor - Center lines on slot featurs

Inventor - Center lines on slot featurs slot drawing callout The drawing must show the orientation of the slot welds as to not confuse direction along the part The above image shows the slots with a vertical orientation slot no limit On the drawing, click on hole callout button and then click on one of the radii of the slot Norm Crawford says: February 21, 2011 at 5:20 am

slot no limit slot Note, Carefully hold the DIMM by the edges to avoid Callout number 1 DIMM ejector tabs Callout number 2 DIMM Remove the

slot provider nexus from the bottom of the drawing The tolerance of the slot in Figure is 004 and the tolerance of the mating from the bottom of the drawing The tolerance of the slot in Figure is 004 and the tolerance of the mating