Guidance Note Hole sizes and positions for preloaded bolts No

slot hole dimension standard   Dan slot demo pragmatic play

10 The distance from the center of an oversized or slotted hole to an edge of a connected part shall be not less than that required for a standard hole to

34mm hole diameters are preferred Larger diameters than these can be used but anchorage capacity may be reduced Holes larger than 36mm and smaller than 32mm Find out how to manipulate your hole callouts made by the hole wizard tool in your

galactic streak slot The token for the slot width is Bolt Diameter and the slot length L is Length So the label should say Ø%Diameter x %Length Slot or In figure the allowance is , meaning that the tightest fit occurs when the slot is machined to its smallest allowable size of and the mating part is